If The Starter Does Not Operate; If The Engine Is Flooded; If The Engine Overheats - MARUTI SUZUKI Alto Manual

Hide thumbs Also See for Alto:
Table of Contents

Advertisement

EMERGENCY SERVICE
NOTICE
After shifting the auto gear shift gear-
shift lever to the "N" position, always
check the gear position indicator in
the instrument cluster shows the "N"
position to make sure that the tran-
saxle is disengaged.
If the transaxle cannot be put in neu-
tral, turn the key from the "OFF" to
the "ON" position, and move the auto
gear shift gearshift lever from "N" to
"D", "M" or "R", then back to "N"
again. Then turn the key from the
"ON" to the "OFF" position.
These procedures may help put the
transaxle in neutral. If the transaxle
still cannot be put in neutral, you can-
not tow the vehicle without using a
towing dolly.
NOTICE
The steering column is not strong
enough to withstand shocks trans-
mitted from the front wheels during
towing. Always unlock the steering
wheel before towing.
8-7
If the Starter Does Not
Operate
1) Try turning the ignition switch to the
"START" position with the headlights
turned on to determine the battery con-
dition. If the headlights go excessively
dim or go off, it usually means that
either the battery is flat or the battery
terminal contact is poor. Recharge the
battery or correct battery terminal con-
tact as necessary.
2) If the headlights remain bright, check
the fuses. If the reason for failure of the
starter is not obvious, there may be a
major electrical problem. Have the vehi-
cle inspected by your Maruti Suzuki
authorised workshop.

If the Engine is Flooded

If the engine is flooded with gasoline, it
may be hard to start. If this happens, press
the accelerator pedal all the way to the
floor and hold it there while cranking the
engine. (Do not operate the starter motor
for more than 15 seconds).

If the Engine Overheats

The engine could overheat temporarily
under severe driving conditions. If the high
engine coolant temperature warning light
comes on as overheating during driving:
1) Turn off the air conditioner, if equipped.
2) Take the vehicle to a safe place and
park.
3) Let the engine run at the normal idle
speed for a few minutes until the high
engine coolant temperature warning
light goes off.
WARNING
If you see or hear escaping steam,
stop the vehicle in a safe place and
immediately turn off the engine to let
it cool. Do not open the hood when
steam is present. When the steam
can no longer be seen or heard, open
the hood to see if the coolant is still
boiling. If it is, you must wait until it
stops boiling before you proceed.
If the high engine coolant temperature
warning light does not go off:
1) Turn off the engine and check that the
water pump belt and pulleys are not
damaged or slipping. If any abnormality
is found, correct it.
53MH0-74E

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Alto k10

Table of Contents