Toshiba RD-XS35SU Owner's Manual page 200

Turning the power off
Press ON/STANDBY button from the remote control or
on the front panel of the recorder.
The "Unloading" icon appears on the right corner of
the top of the screen, and the ON/STANDBY indicator
turns red. Then the power turns off.
Note
• If the recorder freezes for about 15 minutes and will not
respond to any buttons, holding down ON/STANDBY
button on the front panel for about 10 seconds can force
the recorder to turn off. However, this is an emergency
measure, which contains a risk of damage to data or discs.
Avoid casual use of this measure. If you try this while the
recorder is operating properly, especially while the
"Loading" or "Unloading" icon is flashing, it may result in re-
initialization of the HDD.
Startup/finishing (closing) icons
These icons are displayed on the right corner on the
top of the screen. While they are flashing, the recorder
is operating as follows:
Startup, reading a disc, finishing recording
Loading
Unloading a disc, finishing the recorder's
operation
Un
loading
Opening a disc tray
Open
Closing a disc tray
Close
RD-XS35SU/SC_Inst_E_p29-43 31
If a message appears
The recorder may display a message. Each message
varies according to operational status.
To respond, follow the examples below.
Message
e.g.
message
OK
e.g. Select either response (by
highlighting in green) using
/
message
ENTER button.
The message disappears.
Yes No
OK
2 selections
e.g.
Read the message, then press
ENTER button.
The message disappears.
message
OK
1 selection
e.g.
The message disappears
automatically in a few seconds.
message
No selection
06.2.13, 4:33 PM
Set
buttons, then press
31