Connections; Connecting To Television - Toshiba SD-K770KU Owner's Manual

Connecting to television

IMPORTANT!
– You only need to make one video connection
from the following options, depending on the
capabilities of your television.
– Connect the DVD player directly to the televi-
sion.
Using Composite Video Jack(CVBS)
Use the composite video cables (yellow) to connect
A
the DVD player' s VIDEO(CVBS) jack to the video
input jack(or the labled as A/V in,Video In or Com-
posite) on the TV(cable supplied).
To hear the sound of this DVD player through your
TV, use the audio cables(white/red)to connect AU-
DIO OUT(L/R)jacks of the DVD player to correspond-
ing AUDIO IN jacks on the TV(cable supplied).
Using Component Video Jacks(Y PB PR)
Helpful hint: before making or changing any connections, make sure that all the devices are
disconnected from the power outlet.
IMPORTANT!
-The progressive scan video quality is only pos-
sible when using Y P
TV is required.
Use the component video cables (red/blue/green) to
A
connect the DVD player' s Y P
responding Component video input jacks (or labeled
as Y P P ) on the TV (cable not supplied).
b r
Use the audio cables (white/red) to connect AUDIO
B
OUT (L/R) jacks of the DVD player to the correspond-
ing AUDIO IN jacks on the TV (cable not supplied).
Proceed to page 11 for detailed Progressive Scan set
C
up.
Using a RF modulator
IMPORTANT!
-If your TV only has a single Antenna In jack (or
labeled as 75 ohm or RF In), you will need an RF
modulator in order to view the DVD playback on
the TV.
Use the composite video cable (yellow) to connect
A
the DVD player' s CVBS jack to the video input jack
on the RF modulator (cable supplied).
To hear sound of this DVD player through your TV,
use the audio cables(white/red) to connect AUDIO
OUT (L/R) jacks of the DVD player to the correspond-
ing AUDIO IN jacks on the RF modulator (cable sup-
plied).
Use the RF coaxial cable (not supplied) to connect
B
ANTENNA OUT or TO TV jack on the RF modulator
to the ANTENNA IN jack on the television.
Connect the Antenna or Cable TV service signal to
C
the ANTENNA IN or RF IN jack on the RF modulator.
(It may have been connected to your TV previously.
Disconnect it from the TV.)

Connections

P and a progressive scan
B R
P jacks to the cor-
B R