Serial Interface - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Serial interface

Use the micro USB connector for direct communication with the
device. You need a micro USB to USB cable. If the computer
doesn't auto-install a serial port driver, you need to install a serial
port driver on the computer manually.
Use a terminal emulator to connect to the serial interface. For the
most common computer types (PC, MAC) and operating systems,
PuTTY or Tera Term will work.
Parameters:
• Baud rate: 115200 bps
• Data bits: 8
• Parity: None
• Stop bit: 1
• Hardware flow control: Off
Device settings
Serial communication is enabled by default. Use the following
configuration to change the behavior:
SerialPort > Mode
For security reasons, you are asked to sign in before using the
serial interface. Use the following setting to change the behavior:
SerialPort > LoginRequired
If your device is provisioned by CUCM, the serial port settings
should be configured from CUCM.
D15362.16 DX70 and DX80 Administrator Guide CE9.13, JUNE 2020.
Configuration Peripherals
Computer
Flip the
connector cover
up to uncover the
connector panel.
Micro USB
connector
Maintenance
USB
USB to micro USB cable
Flip the connector
cover up to uncover
the connector panel.
DX80
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
209
Administrator Guide
Device settings Appendices Appendices
Video
Micro USB
conferencing
device
DX70
Micro USB
connector