Using Cableclear™ Dnr (Digital Noise Reduction); Selecting The Scan Velocity Modulation (Svm) - Toshiba 42HDX82 Owner's Manual

Using CableClear™ DNR (digital noise reduction)
This feature allows you to reduce visible interference in your TV
picture. This is useful when receiving a broadcast with a weak signal
or playing back a video cassette or disc damaged by repeated use.
™
To turn on CableClear
1. Press MENU, and then press x or • until the PICTURE menu
appears.
2. Press y or z to highlight CableClear DNR (or DNR if you are
in a mode other than ANT1 or ANT2).
3. Press x or • to highlight AUTO.
P CTURE ANTENNA I
MODE PREFERENCE
F L E S H TONE ON
CableClear DNR AUTO
SVM HIGH
COLOR
MED
TEMPERATURE
CONVERGENCE
SAVE NEW PREFERENCE
To turn off CableClear ™
Highlight OFF in step 3 above.

Selecting the Scan Velocity Modulation (SVM)

The SVM feature enhances picture contrast and sharpness. This
feature has three modes: HIGH, LOW, and OFF.
To select the SVM feature:
1. Press MENU, and then press x or • until the PICTURE menu
appears.
2. Press y or z to highlight "SVM."
3. Press x or • to highlight the mode you prefer (HIGH, LOW,
or OFF).
P CTURE ANTENNA I
MODE PREFERENCE
F L E S H TONE ON
CableClear DNR AUTO
SVM HIGH
COLOR
TEMPERATURE MED
CONVERGENCE
PREFERENCE
SAVE NEW
48
DNR:
/ OFF
I UM
DNR:
/ LOW / OFF
I UM
MENU
yzx •
Note:
The "CableClear DNR" display will change to
"DNR" in video mode.
Note:
SVM is not required when viewing some
high-quality video material. If you are
watching high-quality video material, you
may want to set SVM to OFF.