Table of Contents
Advertisement
Using a PS/2 mouse simultaneously with
AccuPoint II
To configure the PS/2 mouse to work with the AccuPoint II:
1
Click Start, Control Panel, then Printers and Other
Hardware.
2
Click the Toshiba HWSetup icon.
3
Select the Pointing Devices tab.
4
Under Pointing Devices Options, select one:
❖
Auto-selected — configures the PS/2 mouse to work
when it is connected at power on, or the AccuPoint II to
work otherwise. Auto-selected is normally the default
option.
❖
Simultaneous — configures both the AccuPoint II mouse
and PS/2 mouse to work with the computer at the same
time. You must reboot the computer for the settings to
take effect.
HINT: When Auto-selected is the default, the computer can't
detect a PS/2 mouse if you connect it after booting the
computer.
This can be changed in Toshiba Hardware Setup.
5
Click OK.
A message appears stating "The changes will take effect next
time the machine is rebooted. Reboot the machine now?"
6
Click Yes.
The computer reboots, and the PS/2 mouse is activated.
Expansion Options
Using a mouse
163
Advertisement
Table of Contents
