General Information; General Information; Operator's Manual; Electrical Drawings - Toro Workman GTX Electric & Lithium Service Manual

General Information

The Workman GTX Electric uses a 48 VDC electrical
system that is an isolated circuit. The vehicle frame is
not used for any ground connections.
The vehicle controller monitors operator and vehicle in-
puts to determine voltage to the traction motor. If a prob-
lem exists that will prevent normal vehicle operation, an
LED on the controller and the status indicator light on the
dash panel will flash a fault code to assist in identifying
the problem.

Operator's Manual

The Operator's Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your Workman vehicle. Refer to the Opera-
tor's Manual for additional information when servicing
the machine.

Electrical Drawings

The electrical schematic and other electrical drawings
for the Workman GTX Electric are located in Chapter 6
-- Electrical Drawings.

Rear Frame Panel Cover

A panel cover is secured to the top of the rear frame be-
hind the seats to prevent debris entry to the front of the
swing arm area. The cover can easily be removed by re-
leasing the latches and lifting the cover from the rear
frame.
Electrical System
After performing any repair on electrical components on
the vehicle, make sure that wiring is routed and secured
so as to prevent abrasion or contact with moving vehicle
parts.
1
FRONT
1. Rear frame
2. Panel cover
Page 3A - - 2
2
3
Figure 1
3. Latch (2 used)
Workman GTX Electric