IBM ESS 5000 SC Series Hardware Manual page 49

a) Type the ID for which you want more information.
b) Press Ctrl+G keys to save.
c) Press Enter to clear the event.
19. Highlight the Set FSP ipmi IP address option to set the HMC1 IP address on the server and then
press c to edit the field. The port is connected to FSP VLAN.
Important: Do not press Enter. Always press c to customize and do the following steps:
a) Type an IP that you want to set in the cmd options field.
A sample output is as follows:
b) Press Ctrl+G keys to save.
c) Press Enter to set the IP.
Note: This is the FSP IP (HMC1) that the customer provided for this server on the worksheet. A
default address is recommended on the 10.0.0.0/24 (netmask 255.255.255.0) subnet.
20. Highlight the Set FSP ipmi static state and netmask option to set the netmask and the HMC1 port to
static. Press Enter if you want a netmask of 255.255.255.0 (/24).
a) If you want to change the netmask, press c to edit the field.
b) Type the new netmask that you want to set.
c) Press Ctrl+G keys to save.
d) Press Enter to set.
21. Highlight the Check FSP (HMC1) interface and then press Enter. This option verifies that the HMC1
IP, static state, and netmask are correctly configured based on your inputs.
Note: If anything is not correct, go back to the associated commands and retry.
Press Enter to continue.
Chapter 3. Installing 37