Table of Contents
Advertisement
Chapter 8 | Towing
7. Raise the jack as far as it will go and place the
handle in its stowed position.
8. Close the receiver lock lever and install the
retainer clip to prevent unwanted opening of
the receiver.
WARNING
If the safety chains are damaged in any
way, do not use the trailer until proper
chains are installed.
damaged safety chains could allow the trailer to
separate from the tow vehicle, resulting in
equipment damage, personal injury, or death.
8-3
October 2014 | Revision 1.0
9. Attach safety chains (1) securely to the tow
10. Connect wiring harness (2) with the seven-pin
11. Connect breakaway system cable (3) to the
(The photo reflects a different trailer model; however,
the hookup method is the same).
(The key must be completely plugged into the socket for
the system to operate properly).
Substandard or
vehicle to prevent unexpected separation.
Cross the chains when attaching.
connector for the lights and brakes.
tow vehicle. Make sure key (4) on the end of
the cable is properly plugged into the receiving
unit.
Meridian Manufacturing, Inc.
Advertisement
Table of Contents
