Table of Contents
Advertisement
WARNING
■
When using Toyota parking assist-sensor
Observe the following precautions.
Failing to do so may result in the vehicle being unable to be driven safely
and possibly cause an accident.
●
Do not use the sensor at speeds in excess of 10 km/h (6 mph).
●
The sensors' detection areas and reaction times are limited. When moving
forward or reversing, check the areas surrounding the vehicle (especially
the sides of the vehicle) for safety, and drive slowly, using the brake to
control the vehicle's speed.
●
Do not install accessories within the sensors' detection areas.
●
The area directly under the bumpers is not detected.
Thin posts or objects lower than the sensor may not be detected when
approached, even if they have been detected before.
■
Side sensors (if equipped)
In the following situations, the clearance sonar may not operate normally
and may result in an unexpected accident. Drive carefully.
●
Objects may not be detected in the side areas until the vehicle is driven for
a short time and a scan of the side areas is completed. (P. 247)
●
Even after the scan of the side areas is completed, objects such as other
vehicles, people or animals that approach from the sides cannot be
detected.
●
Even after the scan of the side areas is completed, objects may not be
detected depending on the surrounding situation of the vehicle.
At that time, the side sensor displays (P. 241) temporary turn off.
■
When to disable the function
In the following situations, disable the function as it may operate even
though there is no possibility of a collision.
●
The vehicle is equipped with a fender pole, wireless antenna or fog lights.
●
The front or rear bumper or a sensor receives a strong impact.
●
A non-genuine Toyota suspension (lowered suspension, etc.) is installed.
●
Towing eyelets are installed.
●
A backlit license plate is installed.
C-HR_HV_OM_General_OM10653E
4-5. Using the driving support systems
249
4
Advertisement
Table of Contents
