Deck Disassembly; Deck Assembly - Toro GrandStand 74504TE Service Manual

MOWER DECK

Deck Disassembly

1. Lower deck to the lowest position.
2. Remove plastic belt covers from the deck.
3. Remove the deck belt from the PTO.
4. Remove the deck from the machine, see "Deck
Removal," page 7-1.
5. Remove belt from the deck.
NOTE: If able to safely lift the deck, support and
rest deck on the rear edge. This will aid in
disassembly.
6. Remove the anti-scalp wheels and mounting
brackets.
7. Remove the discharge chute assembly.
8. Remove the blades from the spindles.
9. Remove the pulley and spindle assemblies from the
deck shell.
10. Remove the torsion idler assembly from the deck
shell.
11. Remove the wire-form covers from the deck shell.
12. Remove the bracket covers from the deck.
13. Remove all 3 baffles from underneath the deck.
NOTE: Lay the deck down for next step.
14. Remove the rear skid plate and bracket assembly
7
from the deck shell.
7-4

Deck Assembly

NOTE: If possible, stand deck shell on back edge
and brace. This will aid in assembly.
1. Assemble and install anti-scalp wheels and
mounting brackets.
2. Install the discharge baffle.
3. Install the curved baffle assembly.
4. Install the straight baffle assembly.
NOTE: Install the straight baffle in the open "c"
position.
5. Attach the rear skid plate to the skid bracket.
6. Attach the rear skid assembly to the deck.
7. Install 4 wire-form covers to the deck.
8. Install the pulleys to the spindles. Secure with nuts.
Torque to 36 +/- 4 ft. lbs.
9. Install the bolt from the bottom of deck through;
hole in deck, pulley spacer, idler pulley, and spacer.
Secure with nut. Torque to 36 +/- 4 ft. lbs.
10. Install the spindle assemblies in the deck. Torque
to 36 +/- 4 ft. lbs.
11. Install bolt though the end of torsion idler arm,
pulley. Secure with nut. Torque to 36 +/- 4 ft. lbs.
NOTE: Grease torsion arm assembly before
installation.
12. Install blades to the spindles. Ensure spacer is
attached. Torque to 105 +/- 5 ft. lbs.
13. Install 3 bracket covers to the deck.
14. Install the deflector assembly to the deck.
15. Install all decals to the deck.
16. Route the belt through pulleys as shown on
diagram (Figure 38).
TORO®- Grandstand Service Instruction Manual