Table of Contents
Advertisement
Installing additional memory (optional)
You need a standard Phillips no. 1 screwdriver to install a
memory module.
To avoid damaging the computer's screws, use a standard
Phillips no. 1 screwdriver that is in good condition.
If you are adding memory after you have started to use the
computer, begin at step 1, otherwise skip to step 2.
1
Turn off the computer via the Start menu.
See
"Using Turn Off or Shut down" on page
The operating system turns off the computer.
2
Unplug and remove any cables connected to the
computer.
3
Close the display panel and turn the computer upside
down to locate the expansion memory slot cover.
Memory slot cover
Base of a Satellite P10/P15 series computer
4
Using a standard Phillips no. 1 screwdriver, unscrew the
two screws that secure the expansion memory slot cover,
then remove the memory slot cover.
Getting Started
94.
63
Advertisement
Table of Contents
