Table of Contents
Advertisement
54
Getting Started
Installing additional memory (optional)
4
Click the TouchPAD ON/OFF tab.
The TouchPAD ON/OFF tab view window appears.
5
Select Disable or Enable, whichever is appropriate.
6
Click Apply.
7
Click OK.
The Mouse Properties window closes.
8
Close the Printers and Other Hardware window.
9
Close the Control Panel window.
NOTE: The Fn + F9 shortcut can be used to enable or disable the
TouchPad (see
Installing additional memory (optional)
CAUTION: Before you install or remove a memory module, turn off
the computer using the Start menu. If you install or remove a
memory module while the computer is in Stand by or Hibernation
mode, data will be lost.
A memory module must be installed in slot A. Do not try to oper-
ate the computer with a memory module in slot B only.
If you install a memory module that is incompatible with the
computer, a beep will sound when you turn on the computer. If the
module is installed in slot A, there will be a long beep followed by
a short beep. If the module is in slot B, there will be a long beep
followed by two short beeps. In this case, turn off the computer
and remove the incompatible module.
"Hot Keys" on page
215).
Advertisement
Table of Contents
