Advertisement
3: General Installation
Before installation please read the following points:
•
When positioning ensure there is adequate access and apply brakes
Before using and switching on the spring system must be set up and
balanced and the plate guides must be set to the correct plate diameter
1.
Remove all packaging & plastic coatings and check for any damage.
2.
Assemble all parts, .
3.
Heated units: Ensure that the heater is located correctly and plugged in.
4.
Ensure all switches and thermostat controls are in the OFF position.
5.
Connect the mains input plug to the socket outlet.
6.
Turn on and check the unit is functioning correctly.
•
Adjustable guides to suit 8" - 12" (203mm - 305mm) diameter plates.
•
Variable spring system to accommodate different plate weights.
•
Each tube can take aroundof 75 plates depending on type
Heated Models:
•
Thermostat controlled air temperature adjustable from 30°C - 110°C
•
Complete with ergonomic black ABS plate cover.
4: Operation
Operation Heated models:
•
Load the Tube & cover plates with
the supplied black ABS plate cover.
•
Switch on the unit using the green switch.
•
Allow approximately 60min to warm the plates before serving.
•
When serving; remove the top plate & the plate below will pop up.
•
Allow all heated units to cool after service before cleaning.
(Cleaning instructions are given on page 11).
4
Advertisement
