Summary of Contents for Moffat HP1
- Page 1 Mobile Plate Dispensers HP1,HP2,UP1&UP2 Operating & Service Manual Manual 027 Issue 001 Feb 2021...
-
Page 2: Table Of Contents
To ensure the best results from this unit please take the time to read and follow all safety, installation and maintenance guidelines carefully before proceeding to install. Keep this manual in a safe place for future consultation. These appliances are CE-marked in compliance with the relevant Low Voltage &... -
Page 3: Electrical Specification
1: Electrical Specification This appliance must be earthed and damaged cables must be replaced by a suitably qualified person! 1 Phase Cable 3 Phase Cable Live (L1) Brown Brown Black Grey Neutral Blue Blue Earth Yellow & Green (Striped) Yellow & Green (Striped) A mains cable, type H07RN-F, conforming to code designation 60245 IEC 57, is supplied. -
Page 4: General Installation
3: General Installation Before installation please read the following points: • When positioning ensure there is adequate access and apply brakes Before using and switching on the spring system must be set up and balanced and the plate guides must be set to the correct plate diameter Remove all packaging &... -
Page 5: Setting The Plate Size
5: Setting Up Plate Diameter Plate Dispensers Additional Setting Up And Commissioning The element on the heated units will remain hot for a period after use. Care should be taken to avoid injury. Setting the Plate Diameter Using one plate only set the guides to their correct positions for the size of plate. - Page 6 6: Setting Up Sping Tension Plates sits on a removable Plate Base Support which in turn rests on a floating platform. This ‘Floating Platform’ in turn, is supported by several tension springs. The tension springs are fastened symmetrically on two sides. In order to access the tension springs the Plate Base Support needs to be removed.
- Page 7 6: Setting Up Sping Tension There must be an equal amount of springs on all four corners. The four corner springs should not be removed. When removing springs, start from the centre outwards. When adding springs work from the corners inwards. Keep the spring numbers symmetrical whenever possible.
- Page 8 6: Setting Up Sping Tension Number of Springs Plate Diameter on Each Corner Total Number of Springs 8” (203mm) 9” (229mm) 10” (254mm) 11” (279mm) 12” (305mm) Below shows the Plate lift set up for the weight of 9” Plates. Only the 3 outer springs are attached to each corner of the Floating Platform.
-
Page 9: Cleaning
11: Cleaning 7: Cleaning Before attempting to clean the unit, please ensure that the Unit is isolated from the electric supply and allowed to cool down, with all food plates and other Dishes removed from the unit. Do not use a water jet or pressure spray to clean this appliance. - Page 10 Thank you for choosing E&R Moffat! Scan the QR code below to visit the E&R Moffat website for further information: E&R Moffat Ltd. www.ermoffat.co.uk Bonnybridge +44 (0) 1324 812272 FK4 2BS sales@ermoffat.co.uk Scotland...