Huawei ePico3801 User Manual page 38

3 ePico3801 Initial Configuration
Procedure
l
l
----End
Postrequisite
After the initial configuration, the following items must be confirmed:
l
l
l
3-4
The ePico3801 accesses the network through the PPPoE dial-up authentication mode.
1. In the WebUI home page, choose Transfer Basic > ETHIP, and then click Del.
2. Choose PPPOELINK and click Add. Then, enter the username and password for the
PPPoE dial-up connection and click Done.
3. The ePico3801 restarts automatically to validate the new configuration.
The ePico3801 accesses the network through the static IP address to be authenticated.
1. In the WebUI home page, choose Transfer Basic > ETHIP, and then click Mod.
2. Change the value of Auto IP to DISABLE and enter the required static IP address,
net mask, and gateway IP address. Then, click Done.
3. The ePico3801 restarts automatically to validate the new configuration.
The corresponding ePico zone has been activated.
The ePico3801 has registered in the corresponding zone.
The network planning parameters of the ePico3801 have been set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ePico3801
User Guide
Issue 01 (2009–09–23)