Installing The Recoil-Starter Rope In The Rope Guide - Toro 29732 Operator's Manual

Figure 3
1. Bolt
3. Move the handle to the operating position
(Figure 4).
Figure 4
1. Handle knob (2)
Important:
Route the cables to the outside
of the handle as you unfold the handle
(Figure 5).
g032765
2. Knob
g032014
Electric-start model shown
1. Cables
2. Wire harness
(electric-start model only)
4. Install the handle knobs and tighten them firmly
by hand.
2
Installing the Recoil-Starter
Rope in the Rope Guide
No Parts Required
Procedure
Important:
To start the engine safely and easily
whenever you use the machine, install the
recoil-starter rope in the rope guide.
Hold the blade-control bar to the upper handle and
pull the recoil-starter rope through the rope guide on
the handle (Figure 6).
5
Figure 5
3. Handle
g025928