Polycom VVX 600 Phone Manual page 6

Telstra VVX 600/601 Phone Guide
Tap Maximum Intensity
Tap the Up or Down soft key to adjust the
intensity
Tap the Back icon to return to the previous
screen
You can connect an Analogue headset to your
phone. When the headset button is pressed it
illuminates green. All calls received will be
answered through the headset. When the
headset is activated, Mute and Volume will take
effect on the headset device.
Tap the headset button again to deactivate the
headset
You set up your phone so that all incoming and
outgoing calls use your headset. At any time
you can switch to handset or speaker mode
From the Home Screen
Tap Settings icon
Tap Basic
Tap Preferences
Tap Headset...
Tap Headset memory...
Tap Enabled
Press the Home button to return to the home
screen
To access Headset memory mode, press the
headset key twice.
The headset button will flash when enabled
Telstra VVX 600/601 Phone Guide | August 2016
If your phone is unable to perform certain tasks,
a warning icon will display in the status
bar. The warning icon lets you know that your
phone has one or more issues that you should
know about. Contact your Customer Group
Administrator to advise them of this issue.
From Line view
Tap the voicemail icon to access voicemail
OR
From the Home view
Tap the Messages icon
Tap Message Centre
Enter a passcode, when prompted; after your
initial login you will need to change your
passcode.
Note: It is essential your passcode is changed
for security reasons. It is important to keep your
new passcode private.
Record your name when prompted
Press the hash key (#)
Follow the prompts to save the recording, or re-
record your name
Tap the Messages button, or dial the
Voice Portal extension.
Enter your passcode followed by the hash key
(#).
Tap the Messages button or dial the Voice
Portal extension.
Press the star key (*) during the greeting.
Enter your mailbox ID (your extension).
Enter your passcode followed by the hash key
(#).
Press 1
Press 1 again
Dial the Voice Portal phone number.
Enter your mailbox ID (your extension) followed
by the hash key (#).
Enter your passcode followed by the hash key
(#).
1... Access your Voice Mailbox
2... Change your CommPilot Express profile†
3... Go to the Greetings Menu
4... Change your Call Forwarding options
6... Make a Call
8... Change your passcode
9... Exit the Voice Portal
#... Repeat this menu
†... Only available if assigned.
Press the Messages button
Enter your passcode and press #
Page 6