Jonsered BC 2228 Operator's Manual page 12

2. Choke: Set the choke control in the choke position.
a WARNING:
When the engine is started with
the choke in choke position the cutting attachment
will start to rotate immediately.
3. Hold the body of the machine on the ground using
your left hand (CAUTION: Not with your foot.). Grip
the starter handle, slowly pull out the cord with
your right hand until you feel some resistance (the
starter pawls grip), then quickly and powerfully pull
the cord. Never twist the starter cord around your
hand.
NOTE! Do not squeeze the throttle control while
attempting to start the engine.
NOTE! Do not pull the starter cord all the way
out and do not let go of the starter handle when
the cord is fully extended. This can damage the
machine. Repeat pulling the cord until engine
attempts to start (or maximum 3 pulls).
4. If the engine starts or attempts to start, push the
choke lever down to the run position.
5. Keep on pulling the cord powerfully until the engine
starts.
6. Once the engine starts, allow the engine to warm
up for 60 seconds before applying full throttle.
„ Warm engine
1. Primer bulb: Press the air purge diaphragm
repeatedly until fuel begins to fill the diaphragm
(about 10 times). The diaphragm need not be
completely filled.
2. Repeat pulling the cord until engine attempts to
start (or maximum 3 pulls).
„ For throttle handles with a start throttle
lock-out:
Set the throttle to the start position by first pressing the
throttle lock-out and the throttle trigger, then pressing
the start throttle button (A). Then release the throttle
lock-out and the throttle trigger, followed by the start
throttle button. The throttle function is now activated.
To return the engine to idle, press the throttle lock-out
and throttle trigger again.
„ Stopping
Stop the engine by pushing and releasing the stop
switch.
CAUTION:
The stop switch automatically
returns to the start position. In order to prevent
unintentional starting, the spark plug cap must be
removed from the spark plug when assembling,
checking and/or performing maintenance.
a WARNING:
When the engine is started with
the choke in the closed position the cutting
attachment will start to rotate immediately.
12