Table of Contents
Advertisement
PICTURE CONTROL ADJUSTMENTS
The picture settings have been factory
adjusted under optimum signal recep-
tion. However, conditions may not be
the same in your area. After tuning in the
unit, allow it to warm up for a few min-
utes. If the picture is not to your liking,
make the following adjustments using
the remote control.
VIDEO Plus+/PROG.
NOTES:
• To resume the normal picture adjustment,
press CANCEL, while in the picture mode
menu.
• The picture settings can only be adjusted by
using
or
and ENTER when they are
displayed on the screen.
• The On-screen display will disappear about
one minute after finishing an adjustment.
14
Preparation
Press TV/VCR to select TV/VCR mode.
1
To adjust the picture, press
MENU.
Press
or
to select the
TV SETUP mode, then press
ENTER.
2
Press
or
to select the
PICTURE mode, then press
ENTER.
3
Press ENTER until your
desired PICTURE mode
appears eg. BRIGHTNESS,
CONTRAST, COLOUR,
SHARPNESS. Then press
or
to adjust the level of the
PICTURE.
(See the below for detail.)
4
After finishing the adjustment, press MENU repeatedly to
return to normal TV screen.
Each time you press ENTER the picture adjustment Screen
changes as follows.
BRIGHTNESS
Press ENTER until "BRIGHTNESS" appears on the screen, then
press
or
to adjust the brightness. When
darker portions of the picture become lighter.
CONTRAST
Press ENTER until "CONTRAST" appears on the screen, then
press
or
to adjust the contrast. Pressing
contrast and enhances the colour. Picture looks sharper in the
daytime by increasing the contrast level and sharper at night by
lowering the contrast level.
COLOUR
Press ENTER until "COLOUR" appears on the screen, then press
or
to adjust the intensity of the colours. This should be set
to where the colours appear normal in intensity and brilliance.
SHARPNESS
Press ENTER until "SHARPNESS" appears on the screen, then
press
or
to adjust the sharpness.
In weak reception areas, the picture may be more pleasing when
the SHARPNESS is set at a lower level.
TIMER REC SET
AUTO REPEAT
OFF
CHANNEL SETUP
TV SETUP
CLOCK SET
SELECT
:
ENTER
: ENTER
EXIT
: MENU
TV SETUP
ON/OFF TIMER SET
PICTURE
NICAM
[AUTO]
AUTO 4:3 DEFAULT [
]
FULL
SELECT
:
ENTER
: ENTER
EXIT
: MENU
BRIGHTNESS
0
SET
:
EXIT : MENU
RESET
: CANCEL
NEXT
: ENTER
is pressed, the
improves the
Advertisement
Table of Contents
