Samsung SPL4225D Owner's Instructions Manual page 16

Remove four large screws from the rear side of the display.
4
Insert the bolts and insulation sinto the
5
ing figure:
ΠBolt
´ Insulation holder
Put the insulation rubber point protruding from the rear top of the display in
6
the groove on the top of the wall attachment panel. Lift up the display a little
bit so that the insulation rubber point at the bottom of the rear side of the
display is put in the groove at the bottom of the wall attachment panel.
(Do not lift the display with any pressure. The insulation rubber at the top may
be taken off. )
16
four screwholes as shown in the follow-
Œ
´