Authorized Power Cords; Charging Procedure - Motorola NNTN4496 Series Manual

68012007024_Multi-Unit Charger.book Page 4 Monday, August 11, 2014 4:39 PM

AUTHORIZED POWER CORDS

This charger is designed for use in 100 VAC to 240 VAC, 50/60 Hz applications
and uses the following Motorola power cords.
Plug Type
No power cord/plug
US/NA
Euro
UK
Brazil
Argentina
OPERATING INSTRUCTIONS
Multi-unit chargers will charge only the Motorola authorized batteries listed in
Table 1. Other batteries may not charge.
The charger pockets will accommodate either a radio with a battery attached or
a battery alone. Prior to charging a battery with radio, turn the radio off.
Batteries charge best at room temperature.

Charging Procedure

1. Plug the charger end of the power supply cord into the power receptacle
located at the back of the charger.
2. Plug the wall receptacle end of the power supply cord into the appropriate
AC outlet. A successful power-up sequence is indicated by a SINGLE
GREEN BLINK on the charger indicator.
3. Insert a battery, or a radio with battery (radio turned off), into the
charger's pocket by:
a. Aligning the groove on each side of the battery with the corresponding
raised rail on each side of the charger pocket
b. Pressing the battery toward the rear of the pocket
c. Sliding the battery into the charger pocket, ensuring complete contact
between the charger and battery contacts
4. When the battery is properly seated in the pocket, the charger indicator
will illuminate STEADY RED to indicate that the battery is charging rapidly.
When the battery is 90% charged, the charger indicator changes to a
BLINKING GREEN, indicating that the battery is trickle charging. When
Table 2: Authorized Power Cords
Charger Kit
NNTN8355
NNTN8353
NNTN8352
NNTN8351
NNTN8347
NNTN8345
4
Power Cord
None
3087791G01
3087791G04
3087791G07
3087791G22
3087791G13