Set and Run Schedule
The schedule function of the DMS can be set through the Web or using the upper
level controller.
Weekly/Yearly schedules can be set and the following information can be
assigned to each schedule:
Item
Schedule
Starting and ending date of a schedule
Period
Set an exception day within a schedule period to
Exception Day
ignore the schedule control
Setup
Indoor unit to
Select indoor units to receive schedule control
be applied
Set indoor unit operation modes
- Indoor unit On time
- Indoor unit Off time
- Set temperature
Event
- Control mode: Heat, Cool, Dry, Fan, and Auto
- Enable/Disable the use of remote controllers
Both the On time and the Off time can not be
set at the same time and only one must be set.
Each schedule can be used selectively by using the run schedule/stop schedule order.
At most 256 schedules can be set.
The indoor units can be controlled by the schedule function of the DMS in at least 1 min. intervals.
Content
Remark
Weekly Repeat:
Maximum 10 events
per day
Daily Repeat:
Maximum 70 events
7
E-