Installing And Connecting The Drain Hose Of The Indoor Unit; Changing Direction Of The Drain Hose - Samsung AVXWVH022EE Installation Manual

Wall-mounted type series
Hide thumbs Also See for AVXWVH022EE:
Table of Contents

Advertisement

Installing and Connecting the Drain Hose of the Indoor Unit

When installing the drain hose for the indoor unit, check if condensation draining is adequate.
When passing the drain hose through the 65-mm hole drilled in the wall, check the following:
The hose must
The end of the drain
NOT slant upwards.
hose must NOT be
placed under water.
Drain hose installation:
1
If necessary, connect the 2-meter extension drain hose to the drain hose.
2
If you use the extension drain hose, insulate the inside of the extension drain
hose with a shield.
3
Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain
hose tightly with a clamp.
 If you don't use the other drain hose hole, block it with a rubber stopper.
4
Pass the drain hose under the refrigerant pipe, keeping the drain hose tight.
5
Pass the drain hose through the hole in the wall. Check if it slants downwards
as seen in the picture.
 The hose will be fixed permanently into position after finishing
the installation and the gas leak test; refer to page 15 for further details.

Changing Direction of the Drain Hose

You can select the direction of the drain hose, depending on where you want to
install the indoor unit.
1
Detach the rubber cap with the flyer.
2
Detach the drain hose by pulling it and turning to the left.
3
Insert the drain hose by fixing it into the groove of the drain hose and the
outlet of the drain pan.
4
Attach the rubber cap with a screwdriver by turning it to the right until it fixes
to the end of the groove.
 One of the diagrams has an illustration with the words "Screws hole" that
should be changed to "Screw hole."
AVXWV@@_IM_E_29819-1_4.14.09.indd 17
Do NOT bend the hose
Keep a clearance of at
in different directions.
least 5cm between the
end of the hose and
the ground.
5cm
less
Ditch
Do NOT place the end
of the drain hose in a
hollow.
Shield
Drain hose
Extension drain hose
Screws hole
Screw
Drain hose
Drain pan outlet
Rubber cap
17
E-
2009-4-14 10:15:42

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents