Canon PIXMA MX870 Service Manual page 13

Non-supported [2002]
hub.
Document cover [2800]
not closed.
Paper jam in the [2801]
ADF.
No paper in the [2802]
ADF.
Paper in the ADF [2803]
is too long.
Duplex printing [2804]
not available with
the paper in the
ADF.
Time-out for the [2700]
scanner device.
ink tank. Printing with an empty ink tank can damage
(Applicable ink the machine.
tank icon) To continue printing without replacing the ink
tank(s), press the Stop button for 5 sec. or
longer to disable the function to detect the
remaining ink amount. After the operation, it
is recorded in the machine that the function to
detect the remaining ink amount was disabled.
--- An unsupported Remove the applicable USB hub from the
USB hub is PictBridge (USB) connector.
connected.
Remove the hub.
--- The feeder cover is Close the document cover, and press the OK
open. Close cover button.
and press [OK].
--- Document in ADF. Remove the paper from the ADF, and press
Redo operation the OK button.
after checking
document in ADF
and pressing [OK].
--- No document in Press the OK button to clear the error.
ADF. Press [OK]
and redo operation
after setting
document.
--- Document size is Remove the paper from the ADF, and press
too long. Redo the OK button.
operation after
checking document
on ADF and
pressing [OK].
--- Document size not Remove the paper from the ADF, and press
suitable for two- the OK button.
sided scanning.
Press [OK] to
cancel operation
and discharge
document.
--- Timeout error has The buffer became full in the middle of
occurred. Press scanning operation, and 60 minutes have
[OK]. elapsed since then, making re-scanning
unstable. Press the OK button to clear the
error.
10 / 63
- Logic board
- PictBridge board
- Logic board
- DF unit
- DF switch unit
- DF unit
- DF unit
- DF unit
- DF unit