Mounting - Furuno Doppler Speedlog DS-50 Installation Manual

4.1 Mounting the Main Display
15
NOTICE
Do not apply paint, anti-corrosive sealant
or contact spray to coating or plastic
parts of the equipment.
Those items contain organic solvents that
can damage coating and plastic parts,
especially plastic connectors.
The main display can be mounted in a panel flush mount or on a
bulkhead Consider the following Points when selecting a mounting.
• Select a location where the display can be easily viewed and
operated.
• Select a location out of direct sunlight and free of water Splash
• The unit weighs 4.5kg Be sure the mounting location is strong
enough to support the weight of the unit.
Flush mounting
Refer to the outline drawing on page D-1 for mounting
dimensions
1. Prepare a cutout in the mounting location referring to Figurer2.1
on the next page.
2 Unfasten four bolts on the front panel to separate the front panel
from the chassis. Save the bolts for later use.
3 Set the chassis to the mounting location and fasten with four
tapping screws (5x16).
Note Leave sufficient slack in cabling so the unit can drawn out
for maintenance and servicing.
4 Connect wires to the terminal strip referring to the next chapter
5 Fasten the front panel to the chassis with four bolts removed at
step2

4 MOUNTING