Table of Contents
Advertisement
Short term storage (less than 1 month)
■ Stop the engine, and allow it to cool before storing.
■ Cover the blade with the blade protector (scabbard).
■ Store the product in a cool, dry, and well-ventilated
place that is inaccessible to children and well away
from sources of ignition.
■ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
■ Do not store outdoors.
DESCRIPTION
See figure 1.
1. Attachment shaft
2. End cap
3. Blade
4. Blade guard
5. Knob
6. Coupler
7. Guide recess
8. Positioning hole
9. Button
10. Second hole
11. Hanger cap
ASSEMBLY
UNPACKING
■ This product has been shipped completely assembled.
■ Make sure that all items listed in the packing list are
included.
■ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, please call
Customer Service for assistance.
PACKING LIST
■ Hedge trimmer attachement
■ Blade guard
■ Operator's manual
English (Original Instructions)
ASSEMBLING THE POWER HEAD TO THE ATTACHMENT
See figure 2.
Never attach or adjust any attachment while power
head is running. Failure to stop the engine may cause
serious personal injury.
The attachment connects to the power head by means of
a coupler device.
■ Loosen the knob on the coupler of the power head
■ Push in the button located on the attachment shaft.
■ Tighten the knob securely.
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious injury or product damage.
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
6
WARNING
shaft and remove the end cap from the attachment
shaft.
Align the button with the guide recess on the power
head coupler and slide the two shafts together. Rotate
the attachment shaft until the button locks into the
positioning hole.
NOTE: If the button does not release completely in
the positioning hole, the shafts are not locked into
place. Slightly rotate from side to side until the button
is locked into place.
WARNING
WARNING
WARNING
WARNING
Advertisement
Table of Contents
