Hyundai IONIQ Electric Owner's Manual page 455

What to do in an emergency
Checking the tire inflation pres-
sure
1. After driving approximately
7 ~ 10 km (4 ~ 6 miles or about
10 minutes), stop at a safe location.
2. Connect the filling hose (3) of the
compressor directly to the tire
valve.
3. Plug the compressor power cord
into the vehicle power outlet.
4. Adjust the tire inflation pressure to
the recommended tire inflation.
With the vehicle ON (
tor ON) proceed as follows.
6-20
- To increase the inflation pres-
sure:
Switch on the compressor, posi-
tion to "I". To check the current
inflation pressure setting, briefly
switch off the compressor.
- To reduce the inflation pres-
sure:
Press the button (9) on the com-
pressor.
OAEE069005
i
Information
The pressure gauge may show higher
than actual reading when the com-
pressor is running. To get an accurate
tire pressure, the compressor needs to
be turned off.
indica-
CAUTION
When you use the Tire Mobility
Kit including sealant
approved by HYUNDAI, the tire
pressure sensors may be dam-
aged by sealant. The sealant on
the tire pressure sensor and
wheel should be removed when
you replace the tire with a new
one and inspect the tire pres-
sure sensors at an authorized
dealer.
i
Information
When reinstalling the repaired or
replaced tire and wheel on the vehicle,
tighten the wheel lug nut to 11~13
kgf·m (80~94 lbf·ft).
not