Enable Cw Up Position; Hc Heating Switch; Set Ra Guiding; Wi-Fi Options - iOptron CEM70 Instruction Manual

89° to +89°. The default limit is 00°. Be careful when setting this limit. It may cause mount goto
problems.

5.4.9. Enable CW Up Position

This setting will allow the CW moving to an up position. The upward angle limit is same as the
meridian flipping setting, or 14 degree at maximum. When this set is enabled, the mount will goto pass
the meridian if an object is close to the meridian, within the angle limit. There will be no meridian flip
when pass the meridian.

5.4.10. HC Heating Switch

Turn on/off the controller LCD back heater. When "Heating ON" is selected, the heater will
automatically be turned on when the ambient temperature reaches 0°C (32°F) and shut off at 10°C.

5.4.11. Set RA Guiding

The function is for CEM70EC only. You can turn off R.A. guiding by selecting "Filter R.A.
Guiding" to allow the high precision encoder to correct the tracking error, or turn the R.A. guiding on by
selecting "Allow RA Guiding" to allow the mount to receive guiding corrections from the guiding
software. The power on default setting is "Allow RA Guiding".

5.4.12. Wi-Fi Options

This function will display WI-FI module functions:
Wi-Fi Status
IP Address & Socket
SSID
Wi-Fi ON/OFF
Restart
Restore to factory
Press BACK to exit

Wi-Fi Status: displays WI-Fi network current status

IP Address and Socket: IP: 010.010.100.254, Socket 08899

SSID: is CEM70_XXXXXX, password 12345678.

Wi-Fi ON/OFF: turn the Wi-Fi on or off

Restart: restart the network adapter

Restore to Factory: restore the factory network setting

5.4.13. Power LED Switch

Use this setting to keep the mount power indicator (LED) on during the operation, or turn it off
automatically after 1 minute

5.4.14. Reset All Settings

Reset all the settings to factory default.

5.4.15. Language

Select one of supported menu languages. Currently it has English and Chinese.
28