The Responsibility Of The Fault - PROEL PLWIN60C User Manual

10. It is necessary to provide some ballasts on the base of the structure. It is possible also apply them by
using cables. It is important to prevent roll over of the structure. The diagram of the ballasts must be
evaluated according to the location of the structure.
11. The structure must be properly assembled and installed according to the instructions in this manual.
12. Be sure to comply with safety standards in legislation for the assembly and disassembly of structures.
13. Before assembling and installing the structure it must be sure to have all the permissions of the
responsible institutions or required by law.
14. All electrical devices hung on the stand or by the stand must absolutely conform to the technical codes
concerning electrical devices (EC NORMS).
15. The stand must only be operated in an exactly vertical position.
16. The stand do not allow to be used on a sloping surface.
17. Load the stand using only adaptive accessories.
18. The load must be centred or evenly distributed on the stand, be careful that the load does not slide to
avoid any overhang of the load.
19. Never move the stand when it is loaded.
20. Never use the stand to carry people.
21. Never lean a ladder on the stand.
22. Never exceed the allowed load limits.
23. Never use the stand in outdoor in typhoon weather condition.
24. It is dangerous to support a very large size load in windy outdoor condition.
25. The stand do not allow to be used on a soft, moveable or yielding surface.
26. All sliding and rotating mechanisms used in bad weather must be regularly lubricated.

8. THE RESPONSIBILITY OF THE FAULT

1. The use of trussing and lifting equipment in temporary or mobile installation is the sole responsibility of
the operator.
2. During the guarantee period, we or one of our contract service organizations undertake to repair, free of
charge any damage attributable to faulty materials.
3. The guarantee does not cover damage due to negligent handling, overload or parts subject to normal
wear and tear.
4. The fitting of replacement parts not supplied by us or modifications of our design by third parties
invalidates the guarantee.
5. The maintenance of security and verification of operation should be performed regularly (annually) by
the operator, even in case of non-intensive use of the lift
13