IKEA RENLIG DWTI60 Manual page 17

ENGLISH
Problem
Malfunction:
The dishwasher
does not fill with
water.
• Continuous flash
of the light of the
running pro-
gramme.
• Intermittent au-
dible signal.
• 2 flashes of the
end indicator
light.
Malfunction:
The dishwasher
will not drain.
• Continuous flash
of the light of the
running pro-
gramme.
• Intermittent au-
dible signal.
• 3 flashes of the
end indicator
light.
Malfunction:
The anti-flood de-
vice operates.
Malfunction:
The programme
does not start.
After the check, switch on the appliance. The programme continues from the point of inter-
ruption. If the malfunction shows again, contact your After Sales Service.
When the cleaning results are not satisfactory:
Problem
The dishes are The selected washing programme
not clean is not applicable for the type of
load and soil.
Possible cause
The connection of the water inlet
hose is not correct. The hose can
be kinked or squashed.
There is a blockage in the sink
spigot.
The connection of the water
drain hose is not correct. The
hose can be kinked or squashed.
Close the water tap and contact your local After Sales Service.
The appliance door is not closed. Close the door.
Mains plug is not connected in.
The fuse has blown out in the
household fuse box.
Delay start is set.
Possible cause
Solution
Make sure that the connection is
correct.
Clean the sink spigot.
Make sure that the connection is
correct.
Put in the mains.
Replace the fuse.
Cancel the delay start to start the
programme immediately.
Solution
Set different washing programme.
17