Kenwood TS-590SG Service Manual page 96

TS-590SG
Item Condition
20. Power PGC 1) Menu No.: 50 (14.1MHz, CW)
Transmit
• 50W
• 25W 2) Menu No.: 51 (14.1MHz, CW)
Transmit
• 10W 3) Menu No.: 52 (14.1MHz, CW)
Transmit
• 5W 4) Menu No.: 53 (14.1MHz, CW)
Transmit
21. FM devia- 1) Menu No.: 54 (29.1MHz, FM)
tion Transmit
• Wide
• Narrow 2) Menu No.: 55 (29.1MHz, FM)
Transmit
22. Current 1) Menu No.: 56 (24.9MHz, USB)
protection Transmit
DC power supply
DC IN: DC 15.9V
23. SWR pro- 1) Menu No.: 57 (14.1MHz, USB)
tection Transmit
DC power supply
DC IN: DC 13.8V
150 dummy connection
: Use a cable that is 1m long
24. SWR meter 1) Menu No.: 58 (14.1MHz, USB)
Transmit
• 14M (SWR: DC power supply
3) DC IN: DC 13.8V
150 dummy connection
: Use a cable that is 1m long
• 50M 2) Menu No.: 59 (50.1MHz, USB)
(SWR: 3) Transmit
DC power supply
DC IN: DC 13.8V
150 dummy connection
: Use a cable that is approx.
18cm long
• Writing data : After items 2~24 have been adjusted;
1) Menu No.: 72
2) [ ] or [ ] key: Push once time. Display "rEAdy" → "good" (If "nG" is displayed, enter data again.)
3) [CLR] key: Push once time.
25. AT detec- 1) Display f.: 51.9MHz
tion balance Mode: FM
Power: 10W
Transmit
96
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Power meter Rear ANT 1 Front
150W ATT panel panel
Power meter
Linear
detector
150W ATT
Ammeter
150 dum-
my load
Through
type power
meter
Oscilloscope Final TP3 Final
Power meter (A/2) (AMP) (A/2)
150W ATT
Adjustment
Parts Method
[ ] Set the adjustment ALC meter 15 dots
or [ value to become
] the specifi ed ALC
meter.
4.1kHz ±0.1kHz
According to the
larger +, –.
2.1kHz ±0.1kHz
According to the
larger +, –.
Set the adjustment 21.0A±0.1A
value within the limit
of the specifi ed cur-
rent.
Set the adjustment 40W±1W
value within the
limit of the specifi ed
power.
[ ] 1 push SWR meter lights up to 3 posi-
tion.
VR5 Turn the VR5 to
the point where the
waveform on the os-
cilloscope changes
from high to low.
(Threshold point)
Specifi cations / Remarks