Table of Contents
Advertisement
2015-18 CHEVROLET CITY EXPRESS CARGO VAN BODY BUILDER MANUAL
WARNING
After removal and installation of the front passenger seat, a zero point reset function must be performed
by a General Motors dealer using a special tool. If zero point reset is not performed, the occupant
classification system may not operate normally which may increase the risk of serious injury or death in
a collision.
WARNING
Do not disturb or modify the front passenger seat wiring. Failure to follow this instruction may cause
incorrect operation of the occupant classification system and front passenger air bag or system failure
and may increase the risk of serious injury or death in a collision.
NOTE:
For complete removal and installation procedure of the front seats, refer to the vehicle service manual.
Basic seat installation uses the following sequence:
1.
Before removing or installing the front seats, turn ignition switch OFF, disconnect both battery terminals
and wait at least 3 minutes.
2.
Place the seat in the vehicle on the mounting stud with the locator pin correctly seated. Make sure there
are no foreign objects under the seat, seat belts, pinched wires or carpeting between the seat mounting
feet and floor.
3.
Fully connect the seat electrical connectors and make sure the inboard and outboard seat tracks are
positioned evenly and locked in place.
4.
Install the front outboard seat bolt and hand tighten only.
5.
Install the front inboard seat bolt and tighten to 40 Nm (30 ft-lb).
6.
Tighten the front outboard seat bolt to 40 Nm (30 ft-lb).
7.
Move the seat forward and install the rear inboard seat bolt. Make sure both seat tracks are locked in
place and tighten to 40 Nm (30 ft-lb).
8.
Install the rear outboard seat nut. Tighten to 40 Nm (30 ft-lb) and install the cap.
9.
Connect the battery.
10.
For front passenger seat, the zero point reset function must be performed by a Chevrolet dealer.
11.
Install all the seat fastener caps.
Pa g e | 60
Advertisement
Table of Contents
