Table of Contents
Advertisement
Wired LAN Related
Q1 <Wake On LAN> function
A
<Wake On LAN> is a function that activates the system in rest mode when a
signal (such as ping or magic packet commands) arrives from network (wired
LAN).
To use <Wake On LAN> function:
1.
Select My Network Places > View network connections from the Desktop.
2.
Click the right button on the touchpad over Local Area Connection, and select
Properties.
3.
Click Configure, and select Power Management tab. Select 'Allow this device to
bring the computer out of standby', then click OK. Restart the system.
- If the system in rest mode is activated when there is no received signal, use the
system after disabling <Wake On LAN> function.
- Connecting wired LAN while using wireless LAN may not execute <Wake On
LAN> function. Configure wireless LAN to 'Disable' to use <Wake On LAN>
function.
1. Click on My Network Place> View network connections on the Desktop.
2. Right-click over Wireless Network Connection and select Disable.
Q2 When I connected 100Mbps wired LAN and the computer exits standby/
hibernate mode, a message informing 10Mbps wired LAN connection
appears.
A
When the computer exits standby/hibernate mode, restoring the network takes
about 3 seconds. When the network is restored, it operates in 100Mbps.
Q3 To network-boot quickly when both the X-Dock and the Wireline LAN port
of the system are both connected to the LAN with the LAN cables,
A
If LAN cables are connected to both ports, because the LAN cable connection
status of X-Dock is checked and the status of the system is checked in sequence,
approximately 2 minutes are required.
To boot quickly, press the <F12> key, press the <Esc> key and select either
'Network Boot from Internal LAN' or 'Network Boot from Dock LAN'.
128 Users Manual
Advertisement
Table of Contents
