Table of Contents
Advertisement
A
The DOS mode which supports 2 Byte characters such as Korean and Japanese
runs in graphic not in text mode. In this case, a broken image may be displayed
while changing the video mode settings.
Q4 In the following cases, the screen blinks or displays noise for a short time:
(Click on the Graphics Related tab, Change Resolution, Change Display
Device, Remove the AC Adapter, Restart the System and then Change the
PowerMizer level.)
A
This may happen while the video driver is examining the connected device.
While detecting, any connected display devices may blink or some noise may
occur.
Q5 When I connect a projector, and change the setting to display screen image
on both the LCD and the projector by pressing <Fn>+<F4/
is not displayed properly.
A
Press <Fn>+<F4 /
If the same problem continues, it means the projector cannot support the
resolution. Lower the resolution to 1024 x 768.
Q6 The playback screen of a DVD title or an MPEG file is only displayed on the
LCD.
A
Video is displayed on a single display device by default, when both LCD and
CRT are selected simultaneously.
1.
Right-click over the Desktop and select Properties from the pop-up menu.
2.
In the [Display Properties] window, select the Settings tab > Advanced >
CATALYST Control Center tab.
3.
Click the ATI CATALYST Control Center button and run the CATALYST
Control Center.
4.
From the View menu, select the Advanced View item.
5.
Select Avivo Video > Theater Mode and set the Clone Mode Overlay Display
item to Theater Mode (Full Screen). You can then view the video on both LCD
and CRT.
Q7 After connecting to a TV, some programs such as Debug, Mem, etc. do not
run in full screen MS-DOS mode.
> keys once again.
> keys, screen
Troubleshooting 121
Advertisement
Table of Contents
