Table of Contents
Advertisement
8. If the external monitor is correctly attached it will be displayed as an icon in the
left hand side of the Devices tab.
To change the Primary device or configuration on your system:
1. Click on the icon for the device or configuration you wish to change to.
2. Click Apply
3. Click OK if satisfied with the changes otherwise they will return to previous
selection in 15 seconds.
Return to Stand Alone Mode
To reset the system to Stand Alone mode:
1. Click on the Notebook icon in the left hand side of the Devices tab.
2. Click Apply.
3. Click OK.
Adjusting the LCD Display
You may wish to adjust the LCD (Liquid-Crystal Display) when you begin using your
computer. A TFT (Thin-Film Transistor) LCD does not require adjustment for contrast
because the contrast is set to remain at maximum.
To adjust the LCD:
Press <Fn+F10> to decrease the display brightness.
Press <Fn+F11> to increase the display brightness.
64 Users Manual
Advertisement
Table of Contents
