Cadillac CT5 2020 Owner's Manual page 44

Cadillac CT5 Owner Manual (GMNA-Localizing-MidEast-13060107) - 2020 -
CRC - 8/29/19
44 SEATS AND RESTRAINTS
Identifying Driver Number
To identify the driver number:
1. Move your remote key away from
the vehicle.
2. Start the vehicle with another
remote key. The DIC should
display the driver number for the
other remote key. Turn the
vehicle off and remove the
remote key from the vehicle.
3. Start the vehicle with the initial
remote key. The DIC should
display the driver number of
your remote key.
Saving Memory Positions
Read these instructions completely
before saving memory positions.
To save preferred driving positions
1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY with remote key 1
or 2.
A DIC welcome message may
indicate driver number 1 or 2.
2. Adjust all available memory
features to the desired driving
position.
3. Press and release SET; a beep
will sound.
4. Immediately press and hold the
1 or 2 memory button matching
the above DIC welcome message
until two beeps sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be
saved and two beeps will not
sound. Repeat Steps 3 and 4.
1 or 2 corresponds to the driver
number. See Identifying Driver
Number previously in this
section.
5. Repeat Steps 1 4 for a second
driver using 1 or 2.
To save the position for and
Seat Exit Memory features, repeat
Steps 1 4 using . This saves the
position for getting out of the vehicle.
Save preferred memory feature
positions to both 1 and 2 if you are
the only driver.
Manually Recalling Memory
Positions
Press and hold 1, 2, or to recall
the previously saved memory
positions if you are driver 1 or 2
identified in the DIC welcome
message.
To stop Manual Memory recall
movement, release 1, 2, or
any of the following controls:
Power seat
Memory SET
Power mirror, with the driver or
passenger side mirror selected
Power steering wheel, if equipped
Seat Entry Memory
The vehicle identifies the number of
the current driver s remote key (1 8).
See Remote Keyless Entry (RKE) System
Operation 0 8. If the remote key is 1 or
2, and Seat Entry Memory is enabled
in vehicle personalization, the
or press