Care And Cleaning - Kohler K-97630 Installation And Care Manual

6. Finish the Install
IMPORTANT! For better adhesion success, allow the locker unit to cure 24 to 48 hours before installing
finished wall material. Removing the 2x4 bracing before the locker unit has cured will result in a loose fit
of the shelves.
Remove the 2x4 bracing from the rough wall once the adhesive on the locker unit has cured.
Install finished wall material up to the edges of the locker unit.
Apply color matched silicone sealant around the entire locker unit.
NOTE: Wait 24 hours before showering or running water.
Prepare the shelves with accessories.
Press the hook into the shelf as shown above.
Press the basket into the shelf as shown above.
TIP: When preparing the two shelves, use water and soap to guide the hook and basket into the
shelves with ease.
Install the shelves into the locker unit.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
Avoid using aerosol products.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water from the surface after
each use.
1248926-2-A 8 Kohler Co.