Rear Side; Daily Check; Checking The Engine Oil Level - Kubota ZG327A-AU Operator's Manual

LIFT-UP POINT

2. Rear side:

1. Hoist the rear frame with a nylon sling. Or jack up
the bottom plate.
Never lift up the battery support.
(1) Rear frame
(2) Nylon sling
(3) Bottom plate
(4) Jack

DAILY CHECK

To prevent trouble from occurring, it is important to
know the condition of the machine. Check it before
starting.
WARNING
To avoid serious injury or death:
• Be sure to check and service the machine on a
level surface with the engine shut off, the key
removed and the parking brake securely set or
the rear wheels chocked.
No.
Walking around Damage of machine body,
the machine 1 tightness of all bolts and
nuts and pins, and so on
2 Fuel and oil leak
Tire pressure, wear and
3
damage
4 Engine oil level
5 Fuel level
6 Bonnet screen
7 Transmission fluid level
8 Brake play
9 Air cleaner primary element
10 Bottom dust cover
11 Area around engine
ZG327A-AU
Ref.
Check item
page
－
－
42
55
51
52
53
53
65
60
54
54
(Continued)
No.
Walking around
12 Machine body cleaning
the machine
Clean around the mower
13
belt.
Clean the hot surface.
14 For example, exhaust mani-
fold or muffler.
Mower 1 Check all hardware.
Make sure all pins are in
2
place
3 Mower deck cleaning
Greasing
4
5 Oil leak
Make sure blade bolts are
6
tight
Blades and belt wear or
7
damage
While sitting in 1 Motion control lever
the operator's
2 Parking brake
seat
3 Other movable parts
Turning the key Performance of the Easy
1
switch "ON" Checker
Starting the en- 1 Color of the exhaust fumes
gine
Check for abnormal noise
2
and vibration.
Engine start system/OPC
system. If either of these do
3 not operate properly, contact
your local KUBOTA Dealer
immediately.
Others Check the areas where pre-
1 vious trouble was experi-
enced.

1. Checking the engine oil level

WARNING
To avoid serious injury or death:
• Always stop the engine and remove the key
before checking the oil.
1. Check the engine oil before starting and 5 minutes
or more after the engine has stopped.
2. Wipe the dipstick area clean.
3. To check the oil level, remove the dipstick, wipe it
clean, replace it, and draw it out again. Check to
see that the oil level is between the 2 notches.
PERIODIC SERVICE
Check item
• Universal joint
• 3 spindle shafts
• Belt tension pulley
• Belt tension pivot
™
light
Ref.
page
－
－
－
－
21
76
55
57
76
76
78
65
56
26
－
－
56
－
51