GMC Cadillac CT5 2021 Manual page 366

19. Return the air only hose (10) and
power plug (9) back to their
original storage location.
20. If the flat tire was able to inflate to
the recommended inflation
pressure, remove the maximum
speed label from the sealant
canister and place it in a highly
visible location.
Do not exceed the speed on this
label until the damaged tire is
repaired or replaced.
21. Return the equipment to its
original storage location in the
vehicle.
22. Immediately drive the vehicle 8 km
(5 mi) to distribute the sealant in
the tire.
23. Stop at a safe location and check
the tire pressure. Refer to Steps 1
10 under Using the Tire Sealant
and Compressor Kit without
Sealant to Inflate a Tire (Not
Punctured).
If the tire pressure has fallen more
than 68 kPa (10 psi) below the
recommended inflation pressure,
stop driving the vehicle. The tire is
too severely damaged and the tire
sealant cannot seal the tire.
If the tire pressure has not dropped
more than 68 kPa (10 psi) from the
recommended inflation pressure,
inflate the tire to the
recommended inflation pressure.
24. Wipe off any sealant from the
wheel, tire, or vehicle.
25. Dispose of the used tire sealant
canister (4) at a local dealer or in
accordance with local state codes
and practices.
26. Replace it with a new canister
available from your dealer.
27. After temporarily sealing a tire
using the tire sealant and
compressor kit, take the vehicle to
an authorized dealer within 161 km
(100 mi) of driving to have the tire
repaired or replaced.
VEHICLE CARE
Using the Tire Sealant and
Compressor Kit without Sealant
to Inflate a Tire (Not Punctured)
The kit includes:
1. Sealant Canister Inlet Valve
2. Sealant/Air Hose
3. Base of Sealant Canister
4. Tire Sealant Canister
5. On/Off Button
6. Slot on Top of Compressor
7. Pressure Deflation Button
8. Pressure Gauge
365