Storing The Channels Automatically; Selecting A Channel Numbered Ten Or Over - Samsung CS-15K10MJ Owner's Instructions Manual

KS1A(TM75)ENG_asia(03121A)
ENG
œ œ
Mode
Adjust
Size
Select Enter
Auto Store
Manual Store
Add/Erase
Fine Tune
Sort
Select Enter
P 1
471 MHz
Exit
Sort
From
To
Store
Select Adjust

Selecting a Channel Numbered Ten or Over

11/6/03 11:28 AM

Storing the Channels Automatically

You can scan the frequency ranges available on your television and
in your country and store all the channels found automatically.
Picture
√
Custom
The channels are stored in the order in which they appear in the
√
frequency bands. It is possible that the automatically allocated
: Normal
numbers may not correspond to those by which you wish to
identify the channels. If this is the case, refer to "Sorting the Stored
Channels" on page 16.
Exit
Channel
√
√
√
√
√
Exit
48 %
Channel
: P 1
: P--
: ?
Exit
When using the numeric buttons to select a channel stored at
programme position ten or higher, follow the instructions below.
12
Page 12
1
Press the MENU ( ) button.
Press the ▲ or ▼ button to select the Channel.
2
3
Press the œ or √ button to select the Auto Store.
4
Press the œ or √ button again.
Result: The horizontal bar is displayed, and then channels are
stored in an order which reflects their positions in the
frequency range. Finally, the search will end automatically.
5
When searching and storing is complete, the Sort menu is
displayed.
To...
Sort the stored channels
into the desired numerical order
Exit the channel store function
without sorting the channels
➣
If sound does not work regularly after storing channels, select
the sound system which best corresponds in
menu (refer to the opposite page).
1
Press the -/-- button.
Result: The "--" symbol is displayed.
2
Enter the two-digit channel number.
Example: To select channel 42, press 4, followed by 2.
Then...
Go to Step 4 of the Sorting
the Stored Channels
procedure on page 16.
Press the MENU ( )
button repeatedly until the
menus disappear.
Manual Store