Copy Function; Firmware Update - TrekStor MovieStation maxi t.uc Manual

8) Copy function

Direct copying of the entire memory card content
To copy the complete content of the memory card, insert the memory card into the
corresponding memory card slot as described in these operating instructions. Keep the
button on your MovieStation pressed for approximately 1 second to start the copy procedure.
The copied files are saved in the "trANSFer" folder in the folder navigation.
i
Copying of individual files
a) In the folder navigation, select the file to be copied.
b) Press the "COPY" button on your remote control. The copy mode is started and the
available storage media appear in the right side of your television screen for selection.
c) By pressing the
folder for the file to be copied. By pressing the
of the screen.
d) To start the copy procedure, press the "COPY" button to copy the file into the selected
target folder.
Caution: If you cancel the started copy procedure by pressing the
a
incompletely copied file might not be able to be executed.
e) To leave the copy mode, press the

9) Firmware update

The firmware is the program responsible for the control of your MovieStation. A firmware
update serves to transfer firmware upgrades to your MovieStation. If you should
encounter any problems with your MovieStation, please make sure that you have installed
the latest firmware version.
a) Download the firmware (*.zip file) from the TrekStor website (www.trekstor.de) and
unzip it in the folder of your choice.
b) For the firmware update, please observe the update instructions supplied with the
firmware.
c) Connect the MovieStation to your computer. Insert the provided power supply into an
electrical outlet, and connect the cable to the "dC iN" connection of the MovieStation.
d) Use the provided USB connection cable to connect the MovieStation to a USB port
on your computer.
e) Turn on the MovieStation by briefly pressing the on/off switch
f ) Copy the unzipped software (*.rom file) to the main directory of the MovieStation.
g) Switch off the MovieStation by pressing the on/off switch
After that, disconnect the MovieStation from your computer.
h) Connect the TrekStor MovieStation to the home entertainment system.
i) Turn on the MovieStation by briefly pressing the on/off switch
j) Confirm the query about the firmware update with "OK".
k) Please wait until the update is complete.
Caution: The software copied into the main directory of the MovieStation must be deleted
a
when the firmware update is complete. Otherwise, a firmware update will start at the next
start-up of the MovieStation with the home entertainment system.
button, switch to the right side of the screen and select the target
F
M
button, you can return to the left side
E
button.
button, the
μ
.
/
and keeping it pressed.
/
.
/
§
EN
31