Omron NX Series Network Connection Manual page 22

3 Right-click NX-ILM400 and click Display Node Location Port.
4 Right-click NX-ILM400 and click Create Device Variable.
The variable name is added to the Variable column.
This completes setting of the device variable.
Additional Information
The device variables are named automatically from a combination of the device name and the
port names.
The default device name are "N" followed by a serial number that starts from 1 in the case of
units mounted on an NX bus master.
Additional Information
In this document, device variables are named automatically in individual slave units. Device
variable names can be set using a user-specified name not by individual slave units but by
each individual port.
8 IO-Link Master Unit Communications Setup
19