Connecting Inlet Hose - Daewoo DWD-HB143 Series Service Manual

Connecting inlet hose

■
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
FOR ORDINARY TAP
1 Pull down the
collar of the inlet
hose to separate it
from the water tap
adapter.
4 Remove the tape,
and screw
connector B into
connector A tightly.
Connector B
Connector A
FOR SCREW-SHAPED TAP
1 Connect the inlet
hose to the water
tap adapter by pulling
down the collar of the
hose end.
Rubber
Connector
Packing
Hose Connector
6
INSTALLATION
2 Loosen the four
screws properly in
order to fit into water
tap.
5 Connect the inlet
hose to the water
tap adapter by pulling
down the collar of the
hose end.
2 Connect the
connector- inlet
supplied if necessary.
Connector
inlet
Rubber
Connector
Packing
Hose Connector
3 Fit the water tap adapter into
the water tap and tighten the
four screws evenly while
pushing up the adapter so
that the rubber packing can
stick to the water tap
tightly.
6 Connect the inlet hose
adapter of the hose to the
water inlet of the washer by
turning it clockwise to be fixed
tightly.
• P lease check the rubber
packing present inside the inlet
hose adapter of the hose.
3 Connect the inlet hose adapter
to the water inlet of the washer
and turn it to be fixed.
• C heck the packing in the inlet.
TAPE