Wired Remote Controller Display (Option) - Fujitsu AS G07KGTA Series Service Instruction

2-1-2 WIRED REMOTE CONTROLLER DISPLAY (OPTION)

2-Wire
1. Check the error
1. If an error occurs, an error icon appears on the "Monitor mode screen".
Touch the [Status] on the "Monitor mode screen".The "Status" screen is displayed.
2. Touch the [Error Information] on the "Status"screen. The "Error Information"screen is displayed.
(If there are no errors, the [Error Information] will not be displayed.)
3. 2-digit numbers correspond to the error code in the table below. Touch the [Next page]
(or [Previous page]) to switch to other connected indoor units.
1.
Mode Set Temp.
For the details of the indoor unit or outdoor unit error , refer to the error codes in each installation manual
2.
! Status
Fri 10:00AM
Fan
Air Flow Direction
VT
[ 1 ]
Individual
[ ]
Economy
[ Off ]
Menu Monitor
Status
3.
Page 1/ 4 Error Information
Address
[ 02 01
Error Code
[ 14 . 15, 41 . 44
Next Error
Back
Page Information
02-03
Page 1/ 5
]
]
Next
Page