Download Print this page
Hasbro Play-Doh DIGGING RIGS Buster the Power Crane Quick Start Manual

Hasbro Play-Doh DIGGING RIGS Buster the Power Crane Quick Start Manual

Advertisement

Quick Links

11K1223-3_49365_PD_Buster_INST_FAR.pdf
CONTENTS:
Buster the Power Crane™ playset with
crane arm and articulating arm, drill bit,
saw, roller, 2 book molds, wrecking ball
(2 pieces), 2 stampers, rail and 4 three-
ounce cans of PLAY-DOH Brand Modeling
Compound (Net wt. 12 oz., 340 g).
x2
1.5 V AA
ALKALINE
BATTERIES
REQUIRED
DEMO
BATTERIES
INCLUDED
1
12/23/11
12:50 PM
NOTICE TO PARENTS: CONTAINS WHEAT.
NONTOXIC. CONFORMS TO ASTM D-4236.
TO INSTALL BATTERIES:
Use a Phillips/cross head screwdriver
(not included) to loosen screw in
battery compartment cover (screw
remains attached to cover). Remove
cover. Insert 2 x 1.5V "AA" or LR6
size alkaline batteries. Replace cover
and tighten screws.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
b. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with for a long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
3

Advertisement

loading

Summary of Contents for Hasbro Play-Doh DIGGING RIGS Buster the Power Crane

  • Page 1 11K1223-3_49365_PD_Buster_INST_FAR.pdf 12/23/11 12:50 PM NOTICE TO PARENTS: CONTAINS WHEAT. TO INSTALL BATTERIES: NONTOXIC. CONFORMS TO ASTM D-4236. Use a Phillips/cross head screwdriver (not included) to loosen screw in battery compartment cover (screw remains attached to cover). Remove cover. Insert 2 x 1.5V “AA” or LR6 size alkaline batteries.
  • Page 2 Product and colors may vary. PLAY-DOH and the PLAY-DOH logo are trademarks identifying quality modeling compound products produced exclusively by Hasbro, Inc. Smash with the © 2011 Hasbro. All Rights Reserved. TM & ® denote U.S. Trademarks. wrecking ball! U.S. Patent No. 6713624. Questions? TROUBLESHOOTING: If your toy doesn’t respond, replace the batteries.