ZyXEL Communications GS-3012 Series User Manual page 235

Table 85 Command Summary: Interface (continued)
COMMAND
name
no
pvid
qos priority
speed-duplex
GS-3012/GS-3012F User's Guide
DESCRIPTION
Sets a name for your interface. Enter a
<port-name-
descriptive name (up to nine printable
string>
ASCII characters).
Disables CIR bandwidth limits on the
bandwidth-limit
port(s).
cir
Disables egress bandwidth limits on the
bandwidth-limit
port(s).
egress
Disables PIR bandwidth limits on the
bandwidth-limit
port(s).
pir
Disables broadcast storm control limit
broadcast-limit
on the port(s).
Disables destination lookup failure
dlf-limit
(DLF) on the port(s).
Disables the outgoing traffic port list for
egress set
a port-based VLAN.
<port-list>
Disables flow control on the port(s).
flow-control
Disables GVRP on the port(s).
gvrp
Disables IGMP filtering on the port.
igmp-filtering
profile
Disables IGMP group limitation.
igmp-group-
limited
Disables IGMP immediate leave on the
igmp-immediate-
port.
leave
Enables the specified interface on the
inactive
switch.
Incoming traffic on the port(s) is not
ingress-check
checked for VLAN tags.
Disables intrusion-lock on a port so that
intrusion-lock
a port can be connected again after you
disconnected the cable.
Disables port mirroring on the port(s).
mirror
Disables multicast limit on the port(s).
multicast-limit
Disables VLAN trunking on the port(s).
vlan-trunking
The default PVID is VLAN 1 for all
<1-4094>
ports. Sets a PVID in the range 1 to
4094 for the specified interface.
Sets the quality of service priority for an
<0 .. 7>
interface.
Sets the duplex mode (half, full) and
<auto|10-
speed (10/100/1000 Mbps) of the
half|10-
connection on the interface. Selecting
full|100-
auto (auto-negotiation) makes one port
half|100-
able to negotiate with a peer
full|1000-full>
automatically to obtain the connection
speed and duplex mode that both ends
support.
Chapter 32 Introducing the Commands
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
235