Bradford White 105-B Specification Sheet

Residential Energy Saver
High Input Direct Vent Water Heater
Features:
1
Bradford White is ISO registered to the
9001
9001 standard.
S T A N D A R D
All residential storage models meet or exceed efficiency requirements
of the Department of Energy. ASHRAE Standard 90.1 b (current
standard) and the National Appliance Energy Conservation Act of 1987
recent amendment effective January 20, 2004 which supercedes all
state and local efficiency requirements.
1" Non-CFC foam insulation—surrounds the tank surface, saving
energy by retarding loss of heat.
Closed combustion—all air for combustion is taken directly from the
outside. The co-axial vent pipe (pipe inside a pipe) draws combustion
air in through the outer pipe (6"), and exhausts the products of
combustion through the inner pipe (4").
Co-axial—rotational venting at top of unit.
Heat Traps—factory installed, minimizes heat loss through piping.
Water Connections—3/4" NPT factory installed true dielectric fittings.
Extends water heater life and eases installation.
No electrical power necessary.
Piezo igniter—for ease of lighting the pilot.
Vitraglas ® lined tank—Bradford White water heater tanks are
protected from the corrosive effects of hot water by an exclusive
ceramic porcelain-like coating. The Bradford White high silica Vitraglas
lining provides a tough interior surface for our water heater tanks.
Factory installed Hydrojet
sediment reducing device. Helps prevent sediment build up in tank.
Increases first hour delivery of hot water while minimizing temperature
build up at top of tank.
Protective magnesium anode rod—provides added protection
against corrosion for long trouble-free service.
Brass drain valve.
T&P relief valve—included.
Side Tappings—for space heating purposes.
Fully automatic controls—automatic temperature selection at your
fingertips. Built-in energy cut-off switch prevents abnormally high water
temperature for extra safety. Built-in gas pressure regulation. Fast-
acting thermostat starts heat recovery cycle sooner.
Optional vent kits—allow for up to 8 foot max vertical and 8 foot
max horizontal (2.4 meters). All DH-1 models must be terminated
horizontally
Six or ten year limited warranty on steel tank—heavy gauge steel
automatically formed, rolled and welded to assure a continuous seam
for glass lining.
Six year limited warranty on parts.
Design certified by CSA International. (formerly AGA and CGA)
MANUFACTURED UNDER ONE OR MORE OF THE FOLLOWING U.S. PATENTS: 7,063,133 B2; 5,954,492;
5,954,492; 5,761,379; 5,943,984; 5,081,696; 5,988,117; 6,142,216; 5,199,385; 5,574,822; 5,372,185; 5,485,879;
5,277,171; (B1)5,341,770; 5,660,165; 5,596,952; 5,682,666; 4,904,428; 5,023,031; 5,000,893; 4,669,448;
4,829,983; 4,808,356; 5,115,767; 5,092,519; 5,052,346; 4,416,222; 4,628,184; 4,861,968; 4,672,919; Re.
34,534. OTHER U.S. AND FOREIGN PATENT APPLICATIONS PENDING. CURRENT CANADIAN PATENTS:
1,272,914; 1,280,043; 1,289,832; 2,045,862; 2,112,515; 2,108,186; 2,107,012; 2,092,105.5.
® Total Performance System—cold inlet
®
EFFICIENCY
RATING
CERTIFIED