Figure 238 Red Hat 9.0: Kde: Network Configuration: Dns; Figure 239 Red Hat 9.0: Kde: Network Configuration: Activate; Using Configuration Files - ZyXEL Communications NBG410W3G User Manual

Appendix B Setting up Your Computer's IP Address
• If you have a dynamic IP address, click Automatically obtain IP address settings
with and select dhcp from the drop down list.
• If you have a static IP address, click Statically set IP Addresses and fill in the
Address, Subnet mask, and Default Gateway Address fields.
3 Click OK to save the changes and close the Ethernet Device General screen.
4 If you know your DNS server IP address(es), click the DNS tab in the Network
Configuration screen. Enter the DNS server information in the fields provided.

Figure 238 Red Hat 9.0: KDE: Network Configuration: DNS

5 Click the Devices tab.
6 Click the Activate button to apply the changes. The following screen displays. Click Yes
to save the changes in all screens.

Figure 239 Red Hat 9.0: KDE: Network Configuration: Activate

7 After the network card restart process is complete, make sure the Status is Active in the
Network Configuration screen.

Using Configuration Files

Follow the steps below to edit the network configuration files and set your computer IP
address.
1 Assuming that you have only one network card on the computer, locate the
eth0
configuration file with any plain text editor.
• If you have a dynamic IP address, enter
following figure shows an example.
374
configuration file (where is the name of the Ethernet card). Open the
eth0
in the
dhcp BOOTPROTO=
NBG410W3G Series User's Guide
ifconfig-
field. The