Table of Contents
Advertisement
6
Setup for Windows 95
and NT 4.0
This chapter contains step by step procedures for installing the
Windows 95 and NT drivers, and configuring Dial-up Networking
for all omni series TA's.
Installing the Windows 95 Driver (INF file)
If your computer supports Plug & Play be sure your TA is powered
on before starting your computer. If you are using a non PnP
protocol follow the steps below to complete installation:
1. From the desk top click the Start button, then choose Settings,
and then click Control Panel.
2. Double click on the Modems icon then click the Add button.
The following dialog box will appear.
3. Select Don't detect my modem; I will select from a list. Then
click Next.
Setup for Windows 95 and NT 4.0 35
Advertisement
Table of Contents
